HP ProCurve 2610-PWR Management And Configuration Manual page 201

■
Syntax: show interfaces [ brief | config ]
Table 10-2. Comparing the "Show Interfaces" Command Options*
Feature
Port Number and Type
Enabled Y/N
Flow Control
Status Up/Down
Mode (Operating)
Intrusion Alert
Mode (Configured)
MDIX Mode
* There is also the show interfaces [[e] < port-number >] option, which displays
port statistics. Refer to "Viewing Port and Trunk Group Statistics and Flow
Control Status" on page B-10.
The figure 10-3 shows an example of the output of the show interface brief
command.
ProCurve(config)# show interfaces brief
Status and Counters - Port Status
Port Type
----- --------- + --------- ------- ------ ---------- ----- ----- ------
1 10/100TX
2 10/100TX
3 10/100TX
4 10/100TX
5 10/100TX
6 10/100TX
7 10/100TX
Figure 10-3. Example Show Interface Brief Command Listing
show interface config: Lists a subset of the data shown by the show
interfaces command (above); that is, only the enabled/disabled, mode, and
flow control status for all ports on the switch.
These two commands display the information listed in
table 10-2, below.
Show Interfaces Brief
| Intrusion
| Alert Enabled Status Mode
| No Yes
| No Yes
| No Yes
| No Yes
| No Yes
| No Yes
| No Yes
Port Status and Basic Configuration
Viewing Port Status and Configuring Port Parameters
Show Interfaces Config
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Operating Configured
Current Operating Mode
MDI
Mode
Up 10FDx MDI
Down 10FDx MDI
Down 10FDx MDI
Down 10FDx MDIX
Down 10FDx MDIX
Down 10FDx MDI
Down 10FDx MDI
Yes
Yes
Yes
No
No
No
Yes
Flow Bcast
Ctrl Limit
off 0
off 0
off 0
off 0
off 0
off 0
off 0
10-9