HP ProCurve 2610-PWR Management And Configuration Manual page 313

Data Type Configuration
Options
Remote Management
Address
4, 6
Type
4
Address Default or
Configured
6
System Name Enable/Disable
6
System Description Enable/Disable
6
Port Description Enable/Disable
System capabilities Enable/Disable
5, 6
supported
System capabilities Enable/Disable
5, 6
enabled
1
The Packet Time-to-Live value is not viewable, but is included in LLDP data packets. (Refer to "Changing the Time-to-
Live for Transmitted Advertisements" on page 13-39.)
2
Subelement of the Chassis ID TLV.
3
Subelement of the Port ID TLV.
4
Subelement of the Remote-Management-Address TLV.
5
Subelement of the System Capability TLV.
6
Populated with data captured internally by the switch. For more on these data types, refer to the IEEE 802.1AB-2005
Standard.
Remote Management Address. The switch always includes an IP address
in its LLDP advertisements. This can be either an address selected by a default
process, or an address configured for inclusion in advertisements. Refer to "IP
Address Advertisements" on page 13-35.
Debug Logging. You can enable LLDP debug logging to a configured debug
destination (Syslog server and/or a terminal device) by executing the debug
lldp command. (For more on Debug and Syslog, see "Debug and Syslog
Operation" on page C-25.) Note that the switch's Event Log does not record
usual LLDP update messages.
Default
N/A Always Enabled
Uses a default address selection method unless an optional address is
configured. See "Remote Management Address", below.
Enabled
Enabled
Enabled
Enabled
Enabled
Configuring for Network Management Applications
LLDP (Link-Layer Discovery Protocol)
Description
Shows the network address type.
Uses the switch's assigned name.
Includes switch model name and running software version,
and ROM version.
Uses the physical port identifier.
Identifies the switch's primary capabilities (bridge, router).
Identifies the primary switch functions that are enabled,
such as routing.
13-33