Need Only A Quick Start; Ip Addressing; To Set Up And Install The Switch In Your Network - HP ProCurve 2610-PWR Management And Configuration Manual

Getting Started

Need Only a Quick Start?

Need Only a Quick Start?

IP Addressing

If you just want to give the switch an IP address so that it can communicate
on your network, or if you are not using multiple VLANs, ProCurve
recommends that you use the Switch Setup screen to quickly configure IP
addressing. To do so, do one of the following:
■
■
For more on using the Switch Setup screen, see the Installation and Getting
Started Guide you received with the switch.

To Set Up and Install the Switch in Your Network

I m po r t a n t !
Use the Installation and Getting Started Guide shipped with your switch for
the following:
■
■
■
■
For the latest version of the Installation and Getting Started Guide and other
documentation for your switch, visit the ProCurve website. (Refer to "Product
Documentation" on page xvii of this guide for further details.)
1-6
Enter setup at the CLI Manager level prompt.
ProCurve# setup
In the Main Menu of the Menu interface, select
8. Run Setup
Notes, cautions, and warnings related to installing and using the
switch and its related modules
Instructions for physically installing the switch in your network
Quickly assigning an IP address and subnet mask, setting a Manager
password, and (optionally) configuring other basic features.
Interpreting LED behavior.