Cli: Management Interface Wizard - HP 3500yl Series Access Security Manual

CLI: Management Interface Wizard

To configure security settings using the CLI wizard, follow the steps below:
1.
This wizard will help you with the initial setup of the various
management interfaces. The current values are shown in brack-
ets[]. Type in a new value, or press <Enter> to keep the cur-
rent value. Press CTRL-C at any time to quit the wizard without
saving any changes. Press ? for help.
Current values are
shown in brackets
Operator password
(Password entries
must be entered
twice and will
Manager password
appear as asterisks.)
Restrict SNMP access to SNMPv3 only
SNMPv2 community name
SNMPv2 Community access level
Telnet enabled
SSH enabled
Web management enabled
Restrict Web access to SSL
Timeout for ssh/telnet sessions
Summary of current
settings (displayed
Operator password
after last wizard
Manager password
option has been set)
Restrict SNMP access to SNMPv3 only
SNMPv2 community name
SNMPv2 Community access level
Telnet enabled
SSH enabled
Web management enabled
Restrict Web access to SSL
Timeout for ssh/telnet sessions
Do you want to save these changes?
To save these settings, press [
To cancel any changes, type [n] (for no), then press [
At the command prompt, type setup mgmt-interfaces.
The welcome banner appears and the first setup option is displayed
(Operator password). As you advance through the wizard, each setup
option displays the current value in brackets [ ] as shown in Figure 1-1.
Welcome to the Management Interface Setup Wizard
].
Enter
].
Enter
Figure 1-1. Example of Management Interface Wizard Configuration
Getting Started with Access Security
[not configured]:
Confirm password:
[*******]:
Confirm password:
[no]:
[notpublic]:
[unrestricted]:
[yes]:
[no]:
[yes]:
[no]:
[0]:
:
:*******
:no
:notpublic
:unrestricted
:yes
:no
:yes
:no
:0
[yes]:
Security Overview
Type in a new
value to change a
setting, or press
<Enter> to keep
the current value.
1-11