Transferring Switch Configurations - HP ProCurve 2610-PWR Management And Configuration Manual

Procurve 2610 series procurve 2610-pwr series
Hide thumbs Also See for ProCurve 2610-PWR:
Table of Contents

Advertisement

File Transfers

Transferring Switch Configurations

N o t e
If an error occurs in which normal switch operation cannot be restored, the
switch automatically reboots itself. In this case, an appropriate message is
displayed after the switch reboots.

Transferring Switch Configurations

Transfer Features
Feature
use TFTP to copy from a remote
host to a config file
use TFTP to copy a config file to a
remote host
use Xmodem to copy a
configuration from a serially
connected host to a config file
Use Xmodem to copy a config file
to a serially connected host
Using the CLI commands described in this section, you can copy switch
configurations to and from a switch.
TFTP: Copying a Configuration from a Remote Host.
Syntax:
This command copies a configuration from a remote host to the startup-config
file in the switch. (Refer to Chapter 6, "Switch Memory and Configuration" for
information on the startup-config file.)
For example, to download a configuration file named sw2610 in the configs
directory on drive "d" in a remote host having an IP address of 10.28.227.105:
ProCurve# copy tftp startup-config 10.28.227.105
A-18
For a Unix TFTP server, the file permissions for the switch software file
do not allow the file to be copied.
Another console session (through either a direct connection to a terminal
device or through Telnet) was already running when you started the
session in which the download was attempted.
copy tftp < startup-config | running-config>< ip-address > < remote-file >
d:\configs\sw2610
Default
Menu
CLI
n/a
below
n/a
page A-19
n/a
page A-19
n/a
page A-20
Web

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ProCurve 2610-PWR and is the answer not in the manual?

Table of Contents

Save PDF