HP ProCurve 2610-PWR Management And Configuration Manual page 139

For example, to use one command to configure the switch with the following:
■
■
■
■
■
you would use the following command sequence:
Figure 7-3. Example of Executing the Console Command with Multiple Parameters
You can also execute a series of console commands and then save the
configuration and boot the switch. For example:
Configure
the
individual
parameters.
Save the
changes.
Boot the
switch.
Figure 7-4. Example of Executing a Series of Console Commands
VT100 operation
19,200 baud
No flow control
10-minute inactivity time
Critical log events
The switch implements the Event Log change immediately. The switch implements
the other console changes after executing
Interface Access and System Information
Interface Access: Console/Serial Link, Web, and Telnet
write memory reload
and .
7-7