HP ProCurve 2610-PWR Management And Configuration Manual page 126

Switch Memory and Configuration
Multiple Configuration Files
If you wanted to experiment with configuration changes to the software
version in secondary flash, you could create and assign a separate startup­
config file for this purpose.
Figure 6-21. Example of Creating and Assigning a New Startup-Config File
N o t e
You can also generate a new startup-config file by booting the switch from a
flash memory location from which you have erased the currently assigned
startup-config file. Refer to "Erasing a Startup-Config File" in the next section.
6-32
ProCurve(config)# copy config config1 config config2
ProCurve(config)# startup-default secondary config config2
ProCurve(config)# show config files
Configuration files:
id | act pri sec | name
---+-------------+---------------------
1 | * * | config1
2 | * | config2
3 | |
The first two commands copy the config1
startup-config file to config2, and then
make config2 the default startup-config
file for booting from secondary flash.