Dhcp/Bootp Operation - HP ProCurve 2610-PWR Management And Configuration Manual

Configuring IP Addressing
IP Configuration
through the switch, configure the switch with an IP address and subnet mask
compatible with your network. The following table lists the general features
available with and without a network-compatible IP address configured.
Table 8-1. Features Available With and Without IP Addressing on the Switch
Features Available Without an IP Address
• Direct-connect access to the CLI and the menu interface.
• Stacking Candidate or Stack Member
• DHCP or Bootp support for automatic IP address
configuration, and DHCP support for automatic Timep
server IP address configuration
• Spanning Tree Protocol
• Port settings and port trunking
• Console-based status and counters information for
monitoring switch operation and diagnosing problems
through the CLI or menu interface.
• VLANs and GVRP
• Serial downloads of operating system (OS) updates and
configuration files (Xmodem)
• L ink test
• Port monitoring
• Password authentication
• Quality of Service
• Authorized IP manager
*Although a Commander can operate without an IP address, doing so makes it unavailable for in-band access in an IP
network.

DHCP/Bootp Operation

Overview. DHCP/Bootp is used to provide configuration data from a DHCP
or Bootp server to the switch. This data can be the IP address, subnet mask,
default gateway, Timep Server address, and TFTP server address. If a TFTP
server address is provided, this allows the switch to TFTP a previously saved
configuration file from the TFTP server to the switch. With either DHCP or
Bootp, the servers must be configured prior to the switch being connected to
the network.
N o t e
For information on configuring DHCP relay, including setting up a DHCP
helper and DHCP Option 82 on the switch, refer to the relevant section in the
IP routing chapter of the Advanced Traffic Management Guide.
8-12
Additional Features Available with an IP Address and
Subnet Mask
• Web browser interface access, with configuration,
security, and diagnostic tools, plus the Alert Log for
discovering problems detected in the switch along with
suggested solutions
• SNMP network management access such as ProCurve
Manager network configuration, monitoring, problem-
finding and reporting, analysis, and recommendations for
changes to increase control and uptime
• TACACS+, RADIUS, SSH, SSL, and 802.1X authentication
• Multinetting on VLANs
• Stacking Commander*
• Telnet access to the CLI or the menu interface
• I GMP
• Timep server configuration
• TFTP download of configurations and OS updates
• IP routing
• P ing test