Cli: Modifying The Interface Access - HP ProCurve series 2500 Management And Configuration Manual

Configuring IP Addressing, Interface Access, and System Information
Interface Access: Console/Serial Link, Web, and Inbound Telnet

CLI: Modifying the Interface Access

Interface Access Commands Used in This Section
show console
[no] telnet-server
[no] web-management
console
Listing the Current Console/Serial Link Configuration. This com-
mand lists the current interface access parameter settings.
Syntax:
This example shows the switch's default console/serial configuration.
Interface Access
Enable/Disable
Console Control
Options
Figure 5-5. Listing of Show Console Command
Reconfigure Inbound Telnet Access. In the default configuration,
inbound Telnet access is enabled.
Syntax:[no] telnet-server
To disable inbound Telnet access:
HP2512(config)# no telnet-server
To re-enable inbound Telnet access:
HP2512(config)# telnet-server
5-18
below
below
page 5-19
page 5-19
show console
Event Log Event
Types To List