General Switch Software Download Rules; Using Tftp To Download Switch Software From A Server - HP ProCurve 2610-PWR Management And Configuration Manual

Procurve 2610 series procurve 2610-pwr series
Hide thumbs Also See for ProCurve 2610-PWR:
Table of Contents

Advertisement

General Switch Software Download Rules

N o t e
Downloading new switch software does not change the current switch con­
figuration. The switch configuration is contained in separate files that can also
be transferred. Refer to "Transferring Switch Configurations" on page A-18.
In most cases, if a power failure or other cause interrupts a flash image
download, the switch reboots with the image previously stored in primary
flash. In the unlikely event that the primary image is corrupted (which may
occur if a download is interrupted by a power failure), the switch goes into
boot ROM mode. In this case, use the boot ROM console to download a new
switch software image to primary flash. Refer to "Restoring a Flash Image" on
page C-45.
Using TFTP To Download Switch Software from a
Server
This procedure assumes that:
Before you use the procedure, do the following:
A switch software image downloaded through the menu interface always
goes to primary flash.
After a switch software download, you must reboot the switch to imple­
ment the newly downloaded code. Until a reboot occurs, the switch
continues to run on the software it was using before the download started.
An switch software file for the switch has been stored on a TFTP server
accessible to the switch. (The switch software file is typically available
from the ProCurve website at www.procurve.com.)
The switch is properly connected to your network and has already been
configured with a compatible IP address and subnet mask.
The TFTP server is accessible to the switch through IP.
Obtain the IP address of the TFTP server in which the switch software file
has been stored.
If VLANs are configured on the switch, determine the name of the VLAN
in which the TFTP server is operating.
Determine the name of the switch software file stored in the TFTP server
for the switch (for example, G0721.swi).
File Transfers
Downloading Switch Software
A-3

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ProCurve 2610-PWR and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents

Save PDF