HP ProCurve 2610-PWR Management And Configuration Manual page 179

N o t e
Deleting an SNTP server when only one is configured disables SNTP unicast
operation.
For example, to select SNTP and configure it with unicast mode and an SNTP
server at 10.28.227.141 with the default server version (3) and default poll
interval (720 seconds):
ProCurve(config)# timesync sntp
ProCurve(config)# sntp unicast
ProCurve(config)# sntp server 10.28.227.141
.
Figure 9-5. Example of Configuring SNTP for Unicast Operation
If the SNTP server you specify uses SNTP version 4 or later, use the sntp server
command to specify the correct version number. For example, suppose you
learned that SNTP version 4 was in use on the server you specified above (IP
address 10.28.227.141). You would use the following commands to delete the
server IP address and then re-enter it with the correct version number for that
server:
Selects SNTP.
Activates SNTP in Unicast mode.
Specifies the SNTP server and accepts the current SNTP server
version (default: 3).
SNTP: Viewing, Selecting, and Configuring
In this example, the Poll Interval and the Protocol
Version appear at their default settings.
Note: Protocol Version appears only when there is an
IP address configured for an SNTP server.
Time Protocols
9-11