HP ProCurve 2610-PWR Management And Configuration Manual page 154

Configuring IP Addressing
IP Configuration
For descriptions of these
parameters, see the
online Help for this
screen.
Before using the DHCP/
Bootp option, refer to
"DHCP/Bootp
Operation" on page 8-12.
Figure 8-1. E xample of the IP Service Configuration Screen without Multiple
2. Press
3. If the switch needs to access a router, for example, to reach off-subnet
4. If you need to change the packet Time-To-Live (TTL) setting, select Default
5. To configure IP addressing, select IP Config and do one of the following:
6. Select the IP Address field and enter the IP address for the switch.
7. Select the Subnet Mask field and enter the subnet mask for the IP address.
8. Press
8-6
VLANs Configured
(for Edit).
[E]
destinations, select the Default Gateway field and enter the IP address of
the gateway router.
TTL and type in a value between 2 and 255 (seconds).
• If you want to have the switch retrieve its IP configuration from a
DHCP or Bootp server, at the IP Config field, keep the value as DHCP/
Bootp and go to step 8.
• If you want to manually configure the IP information, use the Space
bar to select Manual and use the
configuration fields.
, then (for Save).
[Enter] [S]
[Tab] key to move to the other IP