Viewing sFlow Configuration and Status
The following sFlow commands allow you to display sFlow configuration and
status via the CLI.
Syntax: show sflow agent
Syntax: show sflow <receiver instance> destination
Syntax: show sflow <receiver instance> sampling-polling <port-list/range>
The show sflow agent command displays read-only switch agent information.
The version information shows the sFlow version, MIB support and software
versions; the agent address is typically the ip address of the first vlan config
ured on the switch.
Figure 13-11. Example of Viewing sFlow Agent Information
The show sflow <instance> destination command includes information about
the management-station's destination address, receiver port, and owner.
ProCurve# show sflow 2 destination
Max Datagram Size
Datagram Version Support
Figure 13-12. Example of Viewing sFlow Destination Information
Displays sFlow agent information. The agent address is normally
the ip address of the first vlan configured.
Displays information about the management station to which the
sFlow sampling-polling data is sent.
Displays status information about sFlow sampling and polling.
ProCurve# show sflow agent
Administrator, CLI-owned, Instance 2
Configuring for Network Management Applications
Using SNMP Tools To Manage the Switch