Debug Types - HP ProCurve 2610-PWR Management And Configuration Manual

Troubleshooting
Using Logging To Identify Problem Sources

Debug Types

This section describes the types of debug messages the switch can send to
configured debug destinations.
Syntax: [no] debug < debug-type >
C-26
all
Configures the switch to send all debug types to the config­
ured debug destination(s). (Default: Disabled)
event
Configures the switch to send Event Log messages to the
configured debug destination(s). Note: This has no effect
on event notification messages the switch routinely sends
to the Event Log itself. Also, this debug type is automatically
enabled in these cases:
• If there is currently no Syslog server address configured
and you use logging < ip-addr > to configure an address.
• If there is currently at least one Syslog server address
configured and the switch is rebooted or reset.
(Default: Disabled)
dhcp-snooping
Assigns DHCP snooping debug messages to the debug des­
tination
lldp
Assigns LLDP debug messages to the debug destination.