Cli: Modifying The Interface Access - HP Procurve 2650 Management And Configuration Manual

Interface Access
Enable/Disable
Console Control
Options
Figure 6-2. Listing of Show Console Command

CLI: Modifying the Interface Access

Interface Access Commands Used in This Section
show console
[no] telnet-server
[no] web-management
console
Listing the Current Console/Serial Link Configuration. This com-
mand lists the current interface access parameter settings.
show console
Syntax:
This example shows the switch's default console/serial configuration.
Reconfigure Inbound Telnet Access. In the default configuration,
inbound Telnet access is enabled.
Syntax: [no] telnet-server
To disable inbound Telnet access:
HPswitch(config)# no telnet-server
To re-enable inbound Telnet access:
HPswitch(config)# telnet-server
Interface Access, System Information, and Friendly Port Names
Interface Access: Console/Serial Link, Web, and Inbound Telnet
below
below
page 6-6
page 6-6
Event Log Event
Types To List
6-5