Overview
This chapter describes how to view the current port configuration and how
to configure ports to non-default settings, including
■
■
■
■
■
■
■
■
Viewing Port Status and Configuring
Port Parameters
Port Status and Configuration Features
Feature
viewing port status
configuring ports
Note On Connecting
If the switch either fails to show a link between an installed transceiver and
Transceivers to
another device, or demonstrates errors or other unexpected behavior on the
Fixed-Configuration
link, check the port configuration on both devices for a speed and/or duplex
Devices
(mode) mismatch. To check the mode setting for a port on the switch, use
either the Port Status screen in the menu interface (page 10-6) or show
interfaces brief in the CLI (page 10-8).
Enable/Disable
Mode (speed and duplex)
Flow Control
Broadcast Limit
Auto-MDIX
Jumbo Packets
QoS Pass-Through Mode
Using Friendly (Optional) Port Names
Default
n/a
See Table 10-1
on pages 10-4
and 10-5.
Port Status and Basic Configuration
Menu
CLI
page 10-6
page 10-8
page 10-7
page 10-10
Overview
Web
page 10-17
page 10-17
10-3