Platform Microcode Detected Error Exception Symptom Codes; Common Platform Interconnect Exception Symptom Codes - IBM E10 Service Manual

Table 16. 2105 Exception Symptom Codes (ESC) (continued)
ESC Description of ESC
1326 ESCON/Fiber bit error rate test failed
1327 ESCON/Fiber wrap test failed
1328 ESCON/Fiber bit error rate test or wrap test failed

Platform Microcode Detected Error Exception Symptom Codes

The following ESC code values are set for microcode detected errors. The allocated ESC range for
detected errors is '2600'x to '26FF'x.
ESC Description of ESC
2620 LRC Check in the Record Header information or the Key Field
2621 PA Miscompare in the Record Header information
2630 Track pinned in Cache is retryable
2631 Track pinned in Cache is non-retryable
2632 Track pinned retryable threshold exceeded
2633 Track pinned non-retryable threshold exceeded
2640 Invalid record sector detected
2650 Remote Support Access word cannot be obtained from the other Service Processor
26E7 No chaining indicated when CCR status is presented

Common Platform Interconnect Exception Symptom Codes

The following CPI ESC code values are set during analysis. The allocated ESC range for detected errors
is '2700'x to '28FF'x.
ESC Description of ESC
271D Unknown adapter in CPI IOM bay
271E Adapter hardware failure during adapter discovery
2800 IOM error from empty adapter bay slot
2801 Forced error is active in CPI
2802 Fence network or DMA island
2803 Pseudo ESC, see sense bytes 9 and 10 for actual ESC
2804 IOM SERR on adapter bus
2805 Adapter SERR on adapter bus
2806 IOM check sum without supporting check
2807 Adapter SERR can not be isolated
2809 IOM detected adapter check
280A IOM PERR on adapter bus
280B IOM master abort on adapter bus
280C IOM target abort on adapter bus
280D IOM adapter bus error without supporting check
280E IOM adapter bus error counter overflowed
2810 PLX detected SERR on adapter bus
Error Messages, Diagnostic Codes, and Service Reports, CHAPTER 9
2105 Exception Symptom Codes
143