Table of Contents
Advertisement
Configuration Program Progress Indicators
0840
A PCI Ultra/Wide SCSI adapter is being configured.
0935
3.5-inch diskette drive being identified or configured.
Diagnostic Load Progress Indicators
Note: The following progress indicators are not all used when AIX is installed on the 2105 Model E10/E20
If the cluster bay hangs with a code displayed, call the next level of support. The AIX Messages
Guide and Reference book, SC23-2641 has detailed recovery procedures for use by the next level
of support.
c00
AIX Install/Maintenance loaded successfully.
c01
Insert the first diagnostic diskette.
c02
Diskettes inserted out of sequence.
c03
The wrong diskette is in diskette drive.
c04
The loading stopped with a hardware failure.
c05
A diskette error occurred.
c06
The rc.boot configuration shell script is unable to determine type of boot.
c07
Insert the next diagnostic diskette.
c08
RAM file system started incorrectly.
c09
The diskette drive is reading or writing a diskette.
c10
Platform-specific bootinfo command not on boot image.
c20
An unexpected halt occurred, and the system is configured to enter the kernel debug program
instead of entering a system dump.
c21
The .ifconfig command was unable to configure the network for the client network host.
c25
Client did not mount remote miniroot during network install.
c26
Client did not mount the ./usrfile system during the network boot.
c29
The system was unable to configure the network device.
c31
The cluster bay is waiting for the system console port to be defined. This is defined during the
FRU replacement procedure for the I/O planar or I/O planar battery. Repeat the procedure.
Note: This can also occur if the bootable CD is left in the CD-ROM drive.
c32
Progress indicator. The console is a high-function terminal.
c33
A tty terminal attached to serial ports S1 or S2 was selected.
c34
A file was selected. The console messages store in a file.
c40
Configuration files are being restored.
c41
Could not determine the boot type or device.
c42
Extracting data files from diskette.
c43
Could not access the boot or installation tape.
c44
Initializing installation database with target disk information.
c45
Cannot configure the console.
c46
Normal installation processing.
c47
Could not create a physical volume identifier (PVID) on disk.
c48
Prompting you for input.
c49
Could not create or form the JFS log.
c50
Creating root volume group on target disks.
c51
No paging devices were found.
c52
Changing from RAM environment to disk environment.
c53
Not enough space in the /tmp directory to do a preservation installation.
c54
Installing either BOS or additional packages.
c55
Could not remove the specified logical volume in a preservation installation.
c56
Running user-defined customization.
c57
Failure to restore BOS.
c58
Displaying message to turn the key.
c59
Could not copy either device special files, device ODM, or volume group information from RAM to
disk.
c61
Failed to create the boot image.
138
VOLUME 3, ESS Service Guide
Advertisement
Table of Contents
