Safety Engineering Changes; Expansion Enclosure Ground Strap Location (S008419M) - IBM E10 Service Manual

2105 Expansion Enclosure Safety Inspection
2105 Expansion Enclosure
Rear View
Figure 89. 2105 Expansion Enclosure Ground Strap Location (S008419m)
12. Complete the safety inspection by going to "Safety Engineering Changes".

Safety Engineering Changes

1. Ensure all safety engineering changes (ECs) are installed.
2. Reinstall all removed covers.
3. This completes the visual and mechanical safety inspection procedures with the power off.
CAUTION:
Do not attempt to switch on power to the machine until all unsafe conditions are corrected. (1050)
Note: This notice is translated into selected languages. See "Chapter 11: Translation of Cautions and
Danger Notices" on page 181.
CAUTION:
Assume that an electrical safety hazard is present. Perform all continuity, grounding, and power
checks specified during the subsystem installation procedures to ensure that the machine meets
safety requirements. (1051)
Note: This notice is translated into selected languages. See "Chapter 11: Translation of Cautions and
Danger Notices" on page 181.
Perform one of the following:
v Installation:
Return to "Install and Remove" in chapter 5 of the Enterprise Storage Server Service Guide, Volume 2.
v Relocate or discontinue:
1. Perform the electrical safety checks. See "Checking the Customer's Power" through "Check the
Customer's Circuit Breaker with the Power On" in chapter 5 of the Enterprise Storage Server
Service Guide, Volume 2.
Return to "Install and Remove" in chapter 5 of the Enterprise Storage Server Service Guide, Volume
2. Checks are complete.
208
VOLUME 3, ESS Service Guide
18