Display Configuration - IBM E10 Service Manual

10. Watch the operator panel display of the cluster bay being serviced. As the cluster bay powers on, the
firmware test displays EXXX progress codes. Keep logically connecting the service terminal, by
repeating step 5 on page 234 on the service terminal, until progress code E1FB is displayed. (During
the cluster bay power on, the service terminal may be logically disconnected one or more times.)
Immediately look at the service terminal for the display shown below.
As soon as the word Keyboard is displayed at the bottom of the screen, immediately press the
number 1 key on the service terminal. This will initiate loading diagnostics from the CD-ROM drive or
from the SCSI Hard Drive.
RS/6000 RS/6000 RS/6000 RS/6000 RS/6000 RS/6000 RS/6000 RS/6000 RS/6000
RS/6000 RS/6000 RS/6000 RS/6000 RS/6000 RS/6000 RS/6000 RS/6000 RS/6000
RS/6000 RS/6000 RS/6000 RS/6000 RS/6000 RS/6000 RS/6000 RS/6000 RS/6000
Memory Keyboard
====>
Note: During firmware boot the service terminal may be logically disconnected one or more times.
11. After the text-based System Management Services starts, the following screen appears.
System Management Services

1. Display Configuration

2. Multiboot
3. Utilities
4. Select Language
====>
12. Selecting the numbered options provide capabilities described on the following pages.
13. After you have finished using the text-based System Management Services, entering the letter x (for
exit) boots the cluster bay.
Display Configuration
This option provides information about the setup of the cluster bay being serviced. A screen similar to the
following is displayed.
System Management Services Connection
*------*
³X=Exit³
*------*
Appendix B. System Management Service Operation Connection
235