c62
Loading platform dependent debug files
c63
Loading platform dependent data files
c64
Failed to load platform dependent data files
c70
Problem Mounting diagnostic CD-ROM disc
c99
Diagnostics have completed. This code is only used when there is no console.
Fxx
(xx is any number) Call next level of support.
Dump Status Codes
A software error has caused a software dump to occur. One or more of the following progress codes may
display. When the dump is complete, a problem log will be created and should be used for repair. If a code
is displayed for more than 10 minutes, call the next level of support.
00c0
The dump completed successfully.
00c1
The dump failed due to an I/O error.
00c2
A dump, requested by the user, is started.
00c3
The dump is inhibited.
00c4
The dump device is not large enough.
00c5
The dump did not start, or the dump crashed.
00c6
Dumping to a secondary dump device.
00c7
Reserved.
00c8
The dump function is disabled.
00c9
A dump is in progress.
00cc
Unknown dump failure
Other Three Digit Status Codes
If a cluster bay three digit status code is displayed for more than 10 minutes, call the next level of support.
The meaning of these codes can be found in the AIX Messages Guide and Reference book, SC23-2641.
Only PE or engineering will be able to access the AIX command line to carry out the actions needed for
each code. The actions listed in this book may need to be modified for use on the 2105.
Note: Codes 000 to 0cx are defined in "Dump Status Codes". Codes Cxx to Fxx are defined in .
9 and 10 Character Progress Codes
The following table defines the 9 and 10 digit progress codes displayed during the last half of the cluster
bay power on code load.
Table 14. 10 Character Progress Code Table
9 and 10 Character
Description
Progress Codes
Init CPIx
Functional code is configuring the CPI interface where x is the interface number (4,5,6,7). If
the cluster bay stops with this displayed, call the next level of support.
CU000–1060
NVS Lattice Code Update (P2–I6 slot)
CU000–1070
NVS Lattice Code Update (P2–I7 slot)
CU000–3010
RPC Code Update (R1–G1)
CU000–3020
RPC Code Update (R1–G2)
CU000–404B
CPI-4 Lattice Code Update (P2–I4/JB,I/O Attachment Card)
CU000–407B
CPI-5 Lattice Code Update (P2–I7/JB,I/O Attachment Card)
CU000–404A
CPI-6 Lattice Code Update (P2–I4/JA,I/O Attachment Card)
CU000–407A
CPI-7 Lattice Code Update (P2–I7/JA,I/O Attachment Card)
CU000–504B
CPI-4 Flash Code Update (P2–I4/JB,I/O Attachment Card)
Diagnostic Load Progress Indicators
Error Messages, Diagnostic Codes, and Service Reports, CHAPTER 9
139