IBM E10 Service Manual page 120

Codes
Table 10. SP Checkpoints. (continued)
Checkpoint Description
E241 Reset PCI bus
E242 Initialize ISA DMA channel
E243 Setup grackle configuration registers
E244 Enable system speaker and send a beep!
E246 System firmware corrupted, take recover
path
E247 Capture DIMM SPDs into NVRAM
E249 Enter recover paths main code
E24C L2 cache array test fails, system hangs
E24D L2 cache array test fails, system hangs
E297 Start firmware softload path execution
E298 Start firmware recovery path execution
E299 Start C code execution
E600 SSA PCI adapter open firmware has run
successfully
E601 SSA PCI adapter BIST has been started but
failed to complete after four seconds
E602 SSA PCI adapter open firmware has started
E603 SSA PCI adapter BIST has completed with
an error
E604 SSA PCI adapter BIST and following POSTs
have completed successfully
E605 SSA PCI adapter BIST has completed
successfully, the following POSTs have failed
E60E SSA PCI adapter open firmware about to
exit (no stack corruption)
E60F SSA PCI adapter open firmware has run
unsuccessfully
E6FF SSA PCI adapter open firmware about to
exit (with stack corruption)
F0FF Service processor firmware fail
OK SP Ready Waiting for Power-On
READY SP Cluster Bay may be powered off if
CD-ROM tray does not open when the eject
button is pressed
STBY SP Ready, system was shutdown by the
operating system and is still powered on
104
VOLUME 3, ESS Service Guide
Action/ Possible Failing FRU
I/O Planar, see 1 on page 100
I/O Planar, see 1 on page 100
I/O Planar, see 1 on page 100
I/O Planar, see 1 on page 100
I/O Planar, see 1 on page 100
I/O Planar, see 1 on page 100
I/O Planar, see 1 on page 100
I/O Planar, see 1 on page 100
I/O Planar, see 1 on page 100
See 1 on page 100
See 1 on page 100
See 1 on page 100
SSA card, identify the adapter by using "MAP
4540: Cluster Minimum Configuration" in
chapter 3 of the Enterprise Storage Server
Service Guide, Volume 1 to isolate the failing
SSA card
See Action/Possible Failing FRU with
Checkpoint E600
See Action/Possible Failing FRU with
Checkpoint E600
See Action/Possible Failing FRU with
Checkpoint E600
See Action/Possible Failing FRU with
Checkpoint E600
See Action/Possible Failing FRU with
Checkpoint E600
See Action/Possible Failing FRU with
Checkpoint E600
See Action/Possible Failing FRU with
Checkpoint E600
See Action/Possible Failing FRU with
Checkpoint E600
See "Firmware/POST Error Codes" on
page 73 for 4BA10004
None, Normal operation
None, Normal operation
This condition can be requested by a
privileged system user with no faults. See SP
error log for possible operating system fault
indications.