IBM E10 Service Manual page 119

Table 10. SP Checkpoints. (continued)
Checkpoint
E080
E081
E0A0
E0B0
E0C0
E0D0
E0E0
E0E1
E164
E168
E16C
E16D
E16E
E16F
E240
Description
Entering Service Processor emergency
firmware flash recovery process.
Flash update completed - system reboot in
progress
Beginning Bring-Up Phase
Starting CPU BIST
Starting X5 BIST
Creating scan log is slow, wait for completion None
Pulling CPU out of reset
Pull CPU out of reset: OK
Create PCI graphics node (P9)
Create PCI graphics node (S3)
GTX100P Subsystem Open request
GTX100P planar not detected or failed
diagnostics
GTX100P subsystem open successful
GTX100P
Setup Winbond ISA bridge
Error Messages, Diagnostic Codes, and Service Reports, CHAPTER 9
Action/ Possible Failing FRU
Call the next level of support before doing the
following:
1. I/O Planar, OR
2. Insert a new DOS formatted diskette
containing the service processor firmware
into the diskette drive. The image file
name must be spflash.img.
Note: ONLY insert the diskette after the
operator panel displays E080 code.
3. Power the cluster off then on and rerun
the flash recovery.
1. Power the cluster off then on and rerun
the flash recovery.
2. Retry a service processor emergency
flash update (if possible) as documented
in the checkpoint code E080.
3. I/O Planar, see 1 on page 100
4.
5.
1. Service Processor (E10/E20 only)
2. CPU Card
3. I/O Planar (See notes on 72 )
1. CPU Card
2. I/O Planar (See notes on 72 )
3. Service Processor (E10/E20 only)
1. CPU Card
2. I/O Planar (See notes on 72 )
3. Service Processor (E10/E20 only)
1. CPU Card
2. I/O Planar (See notes on 72 )
3. Service Processor (E10/E20 only)
1. CPU Card
2. I/O Planar
3. System Planar (See notes on 72 )
4. Service Processor (E10/E20 only)
See 1 on page 100
See 1 on page 100
See 1 on page 100
See 1 on page 100
See 1 on page 100
See 1 on page 100
I/O Planar, see 1 on page 100
Codes
103