Ssa Disk Drive Module Exception Symptom Code And Service Request Numbers - IBM E10 Service Manual

2105 Exception Symptom Codes
ESC SRN
D100 20XXX
D110 45XXX
D120 21XXX
D120 22XXX
D120 23XXX
D120 24XXX
D120 25XXX
D120 26XXX
D120 27XXX
D120 28XXX
D120 29XXX
D130 33XXX
D140 34000
SSA Disk Drive Module Exception Symptom Code and Service Request
Numbers
The following ESC and SRN code values are set during DDM error analysis. The allocated ESC range for
detected errors is 'E000'x to 'EDFF'x.
Note: These SRNs may also occur with an ESC of 1xxx. See "Service Request Numbers (SRN)" on
page 173
Note: E000 ESCs indicate that error analysis was unable to determine which DDM has failed.
ESC SRN
E000 2A206
E000 50100
E000 50411
E000 50425
E000 60210
E000 60230
E000 60240
E000 7XXXX
E000 80203
E000 80215
E000 80280
E000 D0000
E100 1XXXX
E100 44XXX
E110 4BXXX
E140 D0300
E200 46000
172
VOLUME 3, ESS Service Guide
Description of ESC and SRN
Open SSA link
SSA link opened
Link threshold, no characters received
Link threshold, remote port disabled
Link threshold, link reset failed
Link threshold, retry limit exceeded
Link threshold, hardware error
Link threshold, frame reject
Link threshold, invalid retry status
Link threshold, time-out disable state
Link threshold, time-out ready state
Excessive link configurations
Controller cannot initialize device
Description of ESC and SRN
DDM SSA link failed POST
Attempt to log error against unavailable pdisk
SSA Node failed or noisy
SSA device prevents configuration
DDM has check light on
Drawer (7133) check light on
DDM cannot be configured
DDM missing from SSA loop
DDM has check light on
Drawer (7133) has check light on
DDM cannot be configured
DDM cannot be configured
Drive error
DDM failed
Unable to configure disk drive
DDM failed diagnostic
> 1 member of array not available