Table of Contents
Advertisement
Control enclosure:
Attention: Do not operate the system when the drive assemblies are missing.
Drive assemblies that are missing disrupt the airflow; the drives do not receive
sufficient cooling. You must insert blank carriers into unused drive bays.
Powering on an expansion enclosure:
1. Power on the newly installed enclosures. Use the power switch on each of the
2. Use the information in Table 6 on page 37 to verify the state of the light
Both Figure 38 and Figure 39 show the location of the LEDs on the power supply
units, located at the front of the expansion enclosure. Figure 40 on page 37 shows
the location of the LEDs on the power supply units, located at the rear of the
expansion enclosure. The LEDs are located at position 1 .
1
2
Figure 38. 24 drives and two end caps
1
Figure 39. 12 drives and two end caps
36
Storwize V7000 Unified: Quick Installation Guide
two power supply units in the back of the expansion enclosure.
emitting diodes (LEDs) on on the system. Verify that no faults are detected. See
the Storwize V7000 Unified Problem Determination Guide PDF on the CD if
problems are encountered.
2
Table 5. LED status front of control enclosure. Refers to item [1] in the figures above.
Hardware component
Left enclosure end cap, front
of enclosure
2
LED name and symbol
Power, top
Fault, middle
Identify, bottom
3
3
If power on and no fault is
detected
LED is on.
LED is off.
LED is off.
Advertisement
Table of Contents
