Drives And Two End Caps; Led Status Front Of Control Enclosure Or - IBM Storwize V7000 Quick Installation Manual

|
|
|
|
|
1
|
|
Figure 41. 24 drives and two end caps
|
1
|
|
Figure 42. 12 drives and two end caps
| |
|
|
| | |
| |
| |
|
|
|
|
|
40
Storwize V7000 Unified: Quick Installation Guide
1. Power on the newly installed enclosures. Use the power switch on each of the
two power supply units in the back of the expansion enclosure.
2. Use the information in Table 7 on page 41 to verify the state of the light
emitting diodes (LEDs) on the system. Verify that no faults are detected. See the
Storwize V7000 Unified Problem Determination Guide PDF on the CD if problems
are encountered.
Both Figure 41 and Figure 42 show the location of the LEDs on the power supply
units, located at the front of the expansion enclosure. Figure 43 on page 41 shows
the location of the LEDs on the power supply units, located at the rear of the
expansion enclosure. The LEDs are located at position 1 .
2
2
Table 6. LED status front of control enclosure or expansion enclosure. Refers to item [1] in
the figures above.
Hardware component
Left enclosure end cap, front
of enclosure
2
LED name and symbol
Power, top
Fault, middle
Identify, bottom
3
3
If power on and no fault is
detected
LED is on.
LED is off.
LED is off.