Cisco SPA301 Administration Manual page 81

Customizing Standard Features
Configuring Ring Tones
STEP 3
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide
displayed by the GUI. Set the w parameter equal to the ringtone parameter w
value listed in the table above.
For example, to replace the ringtone in Ring1 with the Warble ringtone, change the
value of the Ring1 field to n=warble;w=7;c=1 or configure as follows in the phone's
configuration file:
• Cisco SPA300 Series or Cisco SPA5XXG
<Ring1 ua="na">n=warble;w=7;c=1</Ring1>
• (Cisco SPA525G or Cisco SPA525G2)
<Ring1 ua="na">n=warble;w=file://Warble.raw;c=1</Ring1>
Click Submit All Changes.
You can also download one of two available ring tones (user ring tone 1 or 2) by
using TFTP:
http://phone_ip_addr/ringtone1?[url]
The [url] syntax is tftp://host[:port]/path.
• The default host is the TFTP host.
• Port is optional. The default port is 69.
• The link is case sensitive.
On the IP phones, user-downloaded ring tones are labeled User 1 and User 2 in
the choices for the Default Ring. On the phone ring tone menu, the User 1 and
User 2 choices are replaced by the corresponding name of the ring tone. Not
Installed appears if the user ring tone slots are not used.
For ring tone User 1 and User 2, the cadence is fixed with the on-time equals to the
duration of the ring tone file and off-time equals to four seconds. The total ring
duration is fixed at 60 seconds. The user ring tone names displayed on the IP
phone screen are derived from the ring tone file header file.
The phone does not require rebooting after downloading a ring tone.
To remove the User 1 ring tone from the phone, set the
http://phone_ip_addr/ringtone1?/delete
3
path
to delete, as follows:
80