Cisco SPA301 Administration Manual page 292

Cisco SPA IP Phone Field Reference
Regional Tab
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide
Parameter
Daylight Saving Time
Rule (continued)
Daylight Saving Time
Enable
DTMF Playback Level
DTMF Playback
Length
Inband DTMF Boost
Description
The <weekday> value equals any value in the range 1-
7 (Monday-Sunday). It can also equal 0. If the
<weekday> value is 0, this means that the date to start
or end daylight saving is exactly the date given. In that
case, the <day> value must not be negative. If the
<weekday> value is not 0 and the <day> value is
positive, then daylight saving starts or ends on the
<weekday> value on or after the date given. If the
<weekday> value is not 0 and the <day> value is
negative, then daylight saving starts or ends on the
<weekday> value on or before the date given. Where:
HH stands for hours (0-23).
mm stands for minutes (0-59).
ss stands for seconds (0-59).
The default Daylight Saving Time Rule is start=4/1/
7;end=10/-1/7;save=1.
NOTE Found in the Time section for the Cisco SPA525G or
Cisco SPA525G2.
Select yes to enable Daylight Saving Time.
NOTE Found in the Time section for the Cisco SPA525G or
Cisco SPA525G2.
Local DTMF playback level in dBm, up to one decimal
place.
Defaults to -16.
Local DTMF playback duration in milliseconds.
Defaults to . 1 .
Controls the amount of amplification applied DTMF
signals.
Choices are OdB, 3dB, 6dB, 9dB, 12dB, 15dB, or 18dB.
Defaults to 12dB.
A
292