Configuring Security, Quality, and Network Features
Setting Security Features
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide
•
PPPoE (PPPoE is only available on the Cisco SPA525G or
Cisco SPA525G2), and configure the following:
-
PPPoE Login Name—The account name assigned by the ISP for
connecting on a PPPoE link.
-
PPPoE Login Password—The password assigned by the ISP.
-
PPPoE Service Name—The service name assigned by the ISP.
The Cisco SPA301 or Cisco SPA501G can be configured by using the IVR. See
Using IVR on IP Phones Without
Configuring Power Settings
The Power-over-Ethernet (PoE) requirements requested of a PoE switch by the
phone can be Normal (default) or Maximum.
When one or more attendant consoles are attached to the phone, use Maximum to
advertise to a PoE switch that the phone might consume up to 12 W.
When no attendant consoles are attached, use Normal to advertise a required power
budget of 6.5 Watts.
To configure the (PoE) requirements, navigate to Admin Login > advanced >
Voice > System. Under Power Setting select Normal or Maximum.
DHCP Option Support
The table shows the DHCP options supported on SPA IP phones:
Network Standard
DHCP option 1
DHCP option 2
DHCP option 3
DHCP option 6
DHCP option 15
DHCP option 41
DHCP option 42
DHCP option 43
Screens.
Subnet mask
Time Offset
Router
Domain name server
Domain name
IP address lease time
NTP Server
Vendor Specific Information
5
148