Cisco SPA301 Administration Manual page 32

Getting Started
Using IVR on IP Phones Without Screens
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide
- 2—Multicast Address—Recites the multicast address.
Press 1 to change, or * to go back.
- 3—CDP—Tells you if CDP is enabled.
Press 1 to change, or * to go back.
- 4—SPCP Auto Detection—Indicates that SPCP auto detection is
enabled.
Press 1 to change, or * to go back.
• 3— Other Options
- 1—Software Version—Recites the software version.
- 2—Primary Extension—Recites the primary extension.
- 3—Reboot—Reboots the phone. Hang up to exit.
- 4—Factory Reset—Restores the phone to the factory default software
and settings. Enter 1 to confirm or * to cancel.
- 5—Debug Server—Recites the address of the debug server.
Press 1 to change, or * to go back.
The following table lists the IVR options that you can enter immediately after
accessing the IVR system.
Number Option
100 Indicates that Dynamic Host Configuration Protocol (DHCP) is enabled.
110 Recites the IP address of the phone.
120 Recites the netmask of the phone.
130 Recites the gateway address.
140 Recites the MAC (hardware) address of the phone.
150 Recites the phone software version.
160 Recites the primary DNS server address.
170 Recites the HTTP port on which the web server listens. Defaults to 80.
180 Recites the IP multicast address (used by the Cisco SPA 9000 to
communicate with the IP phone).
1
31