Selecting A Display Language; Creating A Dictionary Server Script - Cisco SPA301 Administration Manual

Hide thumbs Also See for SPA301:
Table of Contents

Advertisement

Configuring Regional Parameters and Supplementary Services
Localizing Your IP Phone
NOTE
STEP 1
STEP 2
STEP 3
STEP 4
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide

Selecting a Display Language

This section describes how to localize the Cisco SPA300 Series and
Cisco SPA500 Series IP Phone display language. You can define up to nine
languages, in addition to English, to be available and host the dictionaries for each
of the languages on the HTTP or TFTP provisioning server. Language support
follows Cisco dictionary principles.
The Cisco WIP310 does not support localization.
Use the Language Selection parameter to select the phone default display
language. The value must match one of the languages supported by the dictionary
server. The script (dx value) is as follows:
<Language_Selection ua="na">
</Language_Selection>
Defaults to blank; the maximum number of characters is 512. For example:
<Language_Selection ua="na"> Spanish
</Language_Selection>
During startup, the phone checks the selected language and downloads the
dictionary from the TFTP/HTTP provisioning server indicated in the phone
configuration. The dictionaries are available at the support website. See
Appendix B, "Where to Go From Here,"
The end user can change the language of the phone on the phone by following
these steps:
Press the Setup button.
Select Language, then press the Select soft button.
Select Option to change the language.
With the desired language highlighted, press Save.

Creating a Dictionary Server Script

The Dictionary Server Script defines the location of the dictionary server, the
languages available and the associated dictionary. The syntax is:
Dictionary_Server_Script ua="na"/Dictionary_Server_Script
for the website location.
7
211

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents