Cisco SPA301 Administration Manual page 179

Provisioning
Updating Profiles and Firmware
STEP 1
STEP 2
STEP 3
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide
Allow and Configure Profile Updates
The profile updates can be allowed at specified intervals. Updated profiles are
sent from a server to the phone by using TFTP, HTTP, or HTTPs.
To configure a profile update:
Click Admin Login > advanced > Voice > Provisioning.
Under Configuration Profile in the Provision Enable field, choose yes.
Enter the parameters defined in the table:
Parameter
Provision Enable
Resync On Reset
Resync Random Delay
Resync At (HHmm)
Resync At Random Delay
Resync Periodic
Description
Allows or denies resync actions. Defaults to yes.
The device performs a resync operation after
power-up and after each upgrade attempt when
set to yes.
A random delay following the boot-up sequence
before performing the reset, specified in seconds.
In a pool of IP Telephony devices that are
scheduled to simultaneously powered up, this
introduces a spread in the times at which each unit
sends a resync request to the provisioning server.
This feature can be useful in a large residential
deployment, in the case of a regional power
failures.
Time in 24-hour format (hhmm) to resync the
device.
To avoid flooding the server with simultaneously
resync requests from multiple phones set to resync
at the same time, the phone triggers the resync up
to ten minutes after the specified time. If this
parameter is provisioned, the Resync Periodic
parameter is ignored.
Time in seconds between periodic resynchs. If this
value is empty or zero, the device does not resync
periodically.
6
179