Using The V500 Web Interface; Accessing The V500 Web Interface - Polycom V500 Administrator's Manual
Hide thumbs
Also See for V500:
- Administrator's manual (146 pages) ,
- Release note (42 pages) ,
- Getting started manual (34 pages)
Table of Contents
Advertisement
Administrator's Guide for the V500 System
Using the V500 Web Interface
Accessing the V500 Web Interface
5 - 2
You can use the web interface to perform most of the calling and configuration
tasks you can perform on the local system.
To configure your browser to use the web interface:
1.
Be sure that your web browser uses Microsoft Internet Explorer 6.0 or later.
2.
Configure these settings:
•
Allow cookies: Enabled
•
Force pages to reload on every visit to a page: Enabled
To access the system using the web interface:
1.
On a PC, open a web browser.
2.
In the browser address line, enter the system's IP address (for example,
http://255.255.255.255) to go to V500 web interface.
3.
Enter admin as the user name, and the password, if a password has been
established.
You can use the web interface to configure all of the system settings except the remote
management settings. For security reasons, these settings must be configured on the local
system by an administrator.
www.polycom.com/videodocumentation
Advertisement
Table of Contents
Troubleshooting
