Setting Up The System Through A Web Interface - Polycom ReadiConvene MGC+50 Getting Started Manual

ReadiConvene Getting Started Guide
9
10 Move the system to your target network. Mount the system on a rack,
11 Turn on the system and wait five minutes for it to restart. After the
You have finished setting up the system. Go to
ReadiConvene™ System"

Setting up the System Through a Web Interface

To connect the computer to the ReadiConvene appliance, you need one of
the following:
•
•
To connect the computer to the ReadiConvene system
1
2
Go to
18
After the ReadiConvene appliance reboots completely (requires about
five minutes), turn it off.
and connect an Ethernet cable to the Ethernet port on the rear panel.
system has restarted, reopen the SE200 - HyperTerminal window.
Type 1 and press Enter to verify system information.
Crossover cable
Two Ethernet cables and a hub or a switch
Do one of the following:
— Connect the appliance directly to an Ethernet port on the
computer with a crossover cable.
— Connect the appliance and the computer to the same Ethernet
switch or hub using standard Ethernet cables.
Turn on the power for both devices.
"Changing Computer Network
on page 21.
Settings".
"Configuring a
Polycom, Inc.