Connecting Power - Polycom V500 Administrator's Manual

Administrator's Guide for the V500 System

Connecting Power

2 - 4
To connect the system to the LAN:
1. Connect the LAN cable to the LAN connector on the back of the system.
BRI
2. Connect the other end of the LAN cable to the LAN.
After you have finished setting up the system, you will need to configure it to work properly
in your network. Refer to
The V500 system has an external power supply.
Do not use a power supply other than the one supplied with your V500 system. Using the
wrong power supply will void the warranty and may damage your system.
To connect power to the system:
1. Connect the power supply to the power connector on the back of the system.
BRI
2. Connect the power cord to the power supply.
Do not connect the V500 system power cord to a wall outlet until you have connected all
equipment to the system.
LAN connector
Configuring Network Use on page
Power connector
DC IN 12V
LAN
3-1.
DC IN 12V
LAN
www.polycom.com/videodocumentation