Polycom V500 Administrator's Manual page 100

Administrator's Guide for the V500 System
Symptom
Not enough volume during a
call.
Sound effects too loud or too
soft.
You hear the incoming call
ring when you have set
sound effects volume to 0.
Incoming call ring is too loud
or too soft.
You can hear yourself on
your system's monitor.
Cannot enter the Admin
Settings screen.
Low battery icon on the
screen.
7 - 14
Cause
The volume is set too low on the
system.
The volume is set too low on the
monitor.
The people at the far site are too far
from the microphone.
The sound effects volume is not set at
desired level.
The internal ringer is enabled.
The sound effects volume is not set at
desired level.
The far site microphone is too close to
the system's audio speaker. (Far-site
systems with separate microphones
only.)
The far site audio volume may be too
loud.
The system requires a password.
Low batteries in the remote control.
Solution
Turn up the volume using the remote
control.
Turn up the volume on your monitor.
Ask the people at the far site to move
closer to the microphone.
Adjust the sound effects volume on the
Audio Settings screen. If you do not want
to hear sound effects, set the volume to 0.
On the Audio Settings screen, clear the
Enable Internal Ringer option.
Adjust the sound effects volume on the
Audio Settings screen. If you do not want
to hear sound effects, set the volume to 0.
At the far site, make sure the microphone
is placed away from the system's audio
speaker.
Turn down the audio volume at the far site.
Enter the password.
Replace the batteries in the remote
control with 3 AAA batteries.
www.polycom.com/videodocumentation