Installing Batteries In The Remote Control; Powering On The System - Polycom V500 Administrator's Manual
Hide thumbs
Also See for V500:
- Administrator's manual (146 pages) ,
- Release note (42 pages) ,
- Getting started manual (34 pages)
Table of Contents
Advertisement
Installing Batteries in the Remote Control
Powering on the System
© Polycom, Inc.
The remote control uses three AAA batteries, which are included with the system.
To install batteries in the remote control:
1.
Remove the battery cover from the back of the remote control.
2.
Refer to the diagram inside the remote control, and install the batteries in the
orientation shown.
3.
Reinstall the battery cover on the remote control.
After you have connected all your standard and optional equipment, plug the
power cord into a wall outlet.
To power on the system:
>> Press the power switch located at the back of the system.
BRI
Chapter 2 - Setting Up Your System Hardware
DC IN 12V
LAN
Power switch
2 - 5
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the V500 and is the answer not in the manual?
Questions and answers