Figure 7.15 [Setup Fc Host] Screen - Fujitsu Eternus DX60 User Manual

Chapter 7 Setup
> 7.2 Basic Setup
3-2
4
P3AM-3042-06ENZ0 ETERNUS DX60/DX80/DX90 Disk storage system User Guide
A confirmation screen appears.
Click the [OK] button.
The volume is created, and the [Define Host] screen appears.
Set up the host.
Specify information for the server being connected to the ETERNUS DX60/DX80/DX90.
Setting screens will vary depending on the ETERNUS DX60/DX80/DX90 model.
When the Host Affinity function is not used, the host setting is not
IMPORTANT
required.
For Fibre Channel
On the [Setup FC Host] screen, register the Fibre Channel card WWN for the server being
connected to the ETERNUS DX60/DX80/DX90.
When a FC switch is connected to the ETERNUS DX60/DX80/DX90,
IMPORTANT
settings for FC switch and the server (FC host) must be completed in
advance.
(1)
Click the [Add] button on the [Setup FC Host] screen.
(2)
Specify a WWN, server name, and host response.

Figure 7.15 [Setup FC Host] screen

(3)
Specify the other necessary items, and click the [Add] button.
The target FC host is displayed in the "Registered FC Host List" field.
(4)
When adding another FC host, repeat
If another FC host does not need to be added, click the [Done] button.
(5)
Click the [Next >] button.
A confirmation screen appears.
(6)
Click the [OK] button.
The settings are reflected and the [Configure Affinity Group] screen in
Step (2) and
154
Step (3).
Step 5
Copyright 2010 FUJITSU LIMITED
appears.