Fujitsu Eternus DX60 User Manual page 193

Chapter 8 Installing Optional Products
> 8.2 Drive Enclosure Installation
IMPORTANT
Procedure
1
2
3
P3AM-3042-06ENZ0 ETERNUS DX60/DX80/DX90 Disk storage system User Guide
• When expanding multiple drive enclosures, by installing them into the
rack or expanding settings via GUI, make sure to expand one by one.
• Do not install the miniSAS cable (for drive enclosures) or power cord
when installing the drive enclosure in the rack. Connect them in
and Step 6
• Install the disk after expanding the drive enclosure.
Refer to "ETERNUS DX60/DX80/DX90 Disk storage system Package Contents"
and check that no rack mount kit components are missing.
"ETERNUS DX60/DX80/DX90 Disk storage system Package Contents"
Refer
Adjust the rack rails (bracket L (for left side) and bracket R (for right side)) sizes
to fit the rack.
Reposition the M4 screws to adjust the length of the rack rails (brackets) to match the
distance between the front and rear rack pillars. Leave the M4 screws slightly unscrewed,
as the bracket must be attached to the rack before they can be completely tightened.
Bracket L (for left side)
"L" is stamped on the inner
side of the left rack rail.
[Left]
(Front rack pillars)
[Right]
Attach the rack rails (brackets) to the rack.
• If the rack pillars have square (approx. 9mm) holes, screw
holders will need to be used when attaching the rack rails
(brackets).
• Make sure to attach the rack rails (brackets) and rack pillars so
that they fit exactly together without any space between them.
in "8.2.4 Additional Drive Enclosure
(Rear rack pillars)
Loosen the M4 screws,
and adjust the rack rails to
the depth of the rack.
Bracket R (for right side)
"R" is stamped on the inner
side of the right rack rail.
193
Step 5
Installation".
Copyright 2010 FUJITSU LIMITED