Fujitsu Eternus DX60 User Manual page 98

Chapter 5 Installation
> 5.2 Rack Installation
4
5
6
7
P3AM-3042-06ENZ0 ETERNUS DX60/DX80/DX90 Disk storage system User Guide
The four M5 screw positions for the rack rails (brackets) are determined relative to the
drive enclosure base line.
The M5 screws should be inserted in the 1st and 3rd holes above the base line.
[Left]
3rd position
2U
Drive enclosure
(M5 screws)
1st position
(M5 screws)
Base line of
drive enclosure
Rack rails
(Brackets)
Tighten the M4 screws of the rack rails (brackets) that were slightly unscrewed in
Step 2.
For 3.5" type drive enclosures, first remove the front cover.
For details on how to attach the front cover, refer to
Cover" (page 75).
Install the drive enclosure in the rack.
CAUTION
•
Fasten the drive enclosure in the rack.
3.5" type drive enclosure
Use the two thumb screws at the front of the drive enclosure to fasten it in the rack.
Thumb screw
[Right]
3rd position
(M5 screws)
1st position
(M5 screws)
"3.3 Attaching and Removing the Front
Do
When installing or removing the drive enclosure to or from the
rack, make sure to have the right and left sides and the
bottom of the drive enclosure by two or more people. Failure
to do so may cause injury.
(Rear rack pillars)
98
Copyright 2010 FUJITSU LIMITED