Figure 2.10 Power Supply Unit (3.5" Type Controller Enclosure) - Fujitsu Eternus DX60 User Manual

Chapter 2 Components
> 2.1 3.5" Type Controller Enclosure
Power supply unit
Figure 2.10

Figure 2.10 Power supply unit (3.5" type controller enclosure)

IMPORTANT
P3AM-3042-06ENZ0 ETERNUS DX60/DX80/DX90 Disk storage system User Guide
shows the power supply unit.
Each power supply unit has two internal cooling fans.
STATUS LED
Blinks green (
but DC power is turned off.
Glows green (
and DC power is turned on.
Glows orange (
or power supply.
• Each enclosure has two power supply units (PSU#0 and PSU#1). The
power cords must be connected to the inlets of both power supply units.
• Power cords should not be reconnected immediately after being
disconnected. Always wait for the power supply unit's STATUS LED to
completely turn off (about 10 seconds) before reconnecting a
disconnected power cord.
56
Inlet
Power cord connects here.
) when AC power is supplied (power cord is connected)
) when AC power is supplied (power cord is connected)
) to indicate a fault has been detected in a fan
Copyright 2010 FUJITSU LIMITED