Fujitsu Eternus DX60 User Manual page 89

Chapter 5 Installation
> 5.2 Rack Installation
Installation conditions for other rack brands
When installing the ETERNUS DX60/DX80/DX90 in other 19-inch rack brands, make sure that
the following conditions are met.
Note that there is no guarantee that operations will perform properly when other rack brands are
used to install the ETERNUS DX60/DX80/DX90.
• Pitch for mounting holes
EIA standard universal pitch
• Size for mounting holes
The correct hole size for M6 screws
• Load capacity
The maximum load capacity of the rack must be more than the weight of the ETERNUS
DX60/DX80/DX90.
• Unit installation area
The dimensions of the area shown in
5.4.
Rack front door
Figure 5.1
Table 5.4
Area
P3AM-3042-06ENZ0 ETERNUS DX60/DX80/DX90 Disk storage system User Guide
A
E
Unit installation area (when installing other rack brands)
Conditions of the unit installation area (when installing other rack brands)
From the fixed part of the ETERNUS DX60/DX80/DX90
A
on the front side to the inner side of the front door
Space between the rack pillars on the front and back
B
sides (inside dimensions)
From the fixed part of the ETERNUS DX60/DX80/DX90
C
on the back side to the inner side of the rear door
From the fixed part of the ETERNUS DX60/DX80/DX90
D
on the front side to the inner side of the rear door
E Rack mount kit installation area
Figure 5.1 must match the conditions described in
B
D
ETERNUS
DX60/DX80/DX90
Rack pillars
Description
89
C
Rack rails
Rack rear door
Conditions
40mm or more
630mm to 800mm
60mm or more
(recommended)
830mm or more
482mm or more
(recommended)
Copyright 2010 FUJITSU LIMITED
Table