Fujitsu Eternus DX60 User Manual page 54

Chapter 2 Components
> 2.1 3.5" Type Controller Enclosure
• ETERNUS DX60/DX80 iSCSI model
Figure 2.8
Figure 2.8
P3AM-3042-06ENZ0 ETERNUS DX60/DX80/DX90 Disk storage system User Guide
shows the ETERNUS DX60/DX80 iSCSI model controller.
SCU STATUS LED
Glows green ( ) when SCU is normal.
Blinks green ( ) when being charged
(for about one minute after the device power is turned on).
IDENTIFY LED
Blinks blue ( ) or turns off (
identify the enclosure installation locations.
SAS (DE) LINKUP LED
Glows green( ) when link has been established.
SAS (OUT) port
Connector for a miniSAS cable
Used to connect the Controller Enclosure to a Drive Enclosure.
LAN port (1000Base-T/100Base-TX/10Base-T)
(RMT port (left), MNT port (right))
RJ45 connectors for LAN cables
Each controller has two such ports.
ACT LED
Glows green (
LINK LED
Glows green (
ETERNUS DX60/DX80 iSCSI model controller
54
) as ordered via GUI to
iSCSI port (1000Base-T) (0 (left),1 (right))
RJ45 connectors for LAN cables
UNIT READY/FAULT LED
Glows green (
Glows orange (
initialization phase. Also glows orange (
indicate a fault has been detected.
MASTER LED
Glows green (
as the Master CM.
PWC port
This is not used.
FAULT LED
Glows orange ( ) during the post power on
initialization phase. Also glows orange (
indicate an iSCSI port failure has been detected.
LINK LED
Glows green ( ) when link has been established.
) when data is being sent and received.
) when link has been established.
) during normal operation.
) during the post power on
) to
) when the controller is set
) to
Copyright 2010 FUJITSU LIMITED