Figure 7.37 [Setup Network Environment] Screen (When Serverview Is Running) - Fujitsu Eternus DX60 User Manual

Chapter 7 Setup
> 7.4 Monitoring Setup
Also, for events that are detected by ServerView when monitoring the device, refer to
B Events detected by ServerView" (page
Procedure
1
1-1
1-2
1-3
1-4
2
2-1
2-2
P3AM-3042-06ENZ0 ETERNUS DX60/DX80/DX90 Disk storage system User Guide
Set the network environment of the ETERNUS DX60/DX80/DX90.
When the ETERNUS DX60/DX80/DX90 and ServerView management device are in differ-
ent subnet environments, set the Gateway IP address and destination network address in
the [Setup Network Environment] screen of GUI.
Start GUI.
Click [Setup Network Environment] under the [Network Settings] menu on the [Global
Settings] tab in the GUI screen.
The [Setup Network Environment] screen appears.
Specify the necessary items, and click the [Set] button.
Enter the default gateway and any "Allowed IP List" devices.

Figure 7.37 [Setup Network Environment] screen (when ServerView is running)

A confirmation screen appears.
Click the [OK] button.
The network environment is set, and the [Setup Network Environment] screen is
closed.
Set up destination of SNMP Trap.
Select [Setup SNMP Agent] under the [Network Settings] menu on the [Global
Settings] tab in the GUI screen.
The [Setup SNMP Agent] menu screen appears.
Click the [Trap] link on the left of the screen.
The SNMP Trap destination setup screen appears.
229).
174
"Appendix
Copyright 2010 FUJITSU LIMITED