Table of Contents
Advertisement
Chapter 4
Configuring Your Server
This chapter describes the Basic Input Output System (BIOS) configuration.
When you install the server for the first time or install/remove optional devices, thoroughly read this chapter for a better
understanding of the settings.
SYSTEM BIOS ~ SETUP ~
The SETUP utility is provided to make the basic hardware configuration for the server. This utility is pre-installed in the
flash memory of the server and ready to run.
The server is factory-configured with the correct parameters using the SETUP utility. Only use the SETUP utility in the
cases described below.
IMPORTANT:
The SETUP utility is intended for system administrator use only.
The SETUP utility allows you to set a password. The server is provided with two levels
of password: Supervisor and User. With the Supervisor password, you can view and
change all the system parameters of the SETUP utility. With the User password, system
parameters available for viewing and changing are limited.
Do not set any password before installing the OS.
The server contains the latest version of the SETUP utility. Dialog boxes appearing on
your SETUP utility, may thus differ from the descriptions in this manual. If you find
anything unclear, see the online help or ask your service representative.
4-1
Advertisement
Table of Contents
