Pwr-Power; Pxp-Pixel Phase - Christie 599 GS Series Technical Reference

Optimize the projector to display content on a blackboard:
(PST 4)
PWR–Power
Changes the power state of the product.
Commands
Command Description
PWR? Returns the current power state of the
projector.
PWR <0 | 1> Turns the projector on or off.
PWR+STBM <0 | 1> Places the projector in standby mode when
connected to AC power.
Examples
Get the projector power status:
(PWR?)
PXP–Pixel Phase
Adjusts the phase of the pixel sampling clock relative to the incoming signal.
You can fine tune the sampling point within one pixel. Adjust the Pixel Phase when the image (usually
from an RGB source) shows shimmer. If the shimmer is concentrated in vertical bands with little or no
shimmer between the bands, the pixel tracking might need adjustment. Pixel Tracking must be set
correctly before adjusting Pixel Phase.
The Pixel Phase command can only be set on analog input cards.
Commands
Command Description
PXP <value> Sets the pixel phase for the specified value.
Examples
Set the pixel phase to 50:
(PXP 50)
GS Series 599 Serial Commands Technical Reference
020-102403-02 Rev. 1 (04-2017)
Copyright 2017 Christie Digital Systems USA Inc. All rights reserved.
©
Serial API commands
Values
—
0 = Turns off the projector
1 = Turns on the projector
0 = 0.5 W mode
1 = Communication mode (Default)
Values
0 to 100
50 (Default)
51