Pwr-Power; Pxp-Pixel Phase - Christie DWU1612-HS Technical Reference

Optimize the projector to display DICOM SIM content:
(PST 4)
PWR–Power
Changes the power state of the product.
Commands
Command Description
PWR? Returns the power settings for the display.
(Read-only)
PWR <0 | 1> Turns the projector on or off.
PWR+STBM<0 | 1> Places the projector in standby mode when
connected to AC power
Examples
Get the projector power status:
(PWR?)
Place the projector in communication mode:
(PWR+STBM 1)
PXP–Pixel Phase
Adjusts the phase of the pixel sampling clock relative to the incoming signal.
You can fine tune the sampling point within one pixel. Adjust the Pixel Phase when the image (usually
from an RGB source) shows shimmer. If the shimmer is concentrated in vertical bands with little or no
shimmer between the bands, the pixel tracking might need adjustment. Pixel Tracking must be set
correctly before adjusting Pixel Phase.
The Pixel Phase command can only be set on analog input cards.
Commands
Command Description
PXP <value> Sets the pixel phase for the specified value.
DWU1612-HS/DWU2022-HS Technical Reference–Serial Commands
020-103352-01 Rev. 1 (03-2020)
Copyright © 2020 Christie Digital Systems USA, Inc. All rights reserved.
Serial API commands
Values
—
0 = Turns off the projector
1 = Turns on the projector
0 = 0.5 W mode—low power mode
1 = Communication mode—normal power
mode (Default)
Values
0 to 100
50 (Default)
56