Using The Keypads - Christie Roadster S+12K Setup Manual

Status Display (error codes) &
Status Display Window 
Keypads &
Sensors 
3.3 Using the
Keypads
Roadster, Matrix WU, Mirage S+/HD/WU Setup Guide
020-100342-02 Rev. 1 (04-2011)

Displays incoming voltage level reaching the projector.
VOLTMETER -

SWITCH/BREAKER -
o It is a power switch for the projector
o It protects against excessive AC conditions (15A or more for
Roadster S+12K/HD12K and Mirage HD12/WU12/S+12K, 20A
or more for Roadster S+16K/Mirage S+14K/S+16K, and 25A or
more for Roadster S+ 20K/HD18K/Mirage WU18/HD18/S+20K).
If the projector is faulty or excessive AC is detected, the breaker
will "trip" to OFF in order to prevent damage. Try moving the
breaker ON again - if the breaker continues to trip OFF, this
indicates a major fault and the AC problem must be resolved.
Possible causes might include shorts, damage to lamp cables, or
excessive AC.
NOTE: This switch turns on the ballast only —it does not power up the projector
or start the lamp. You must press
TWO-DIGIT STATUS/ERROR CODE WINDOW -
display is adjacent to the built-in keypad. During normal operation, the "Power"
light is steady yellow and indicates "on". When the status of the projector
changes, the LED displays a two-digit code number representing the projector's
new status. In addition to the numeric readout, there are two decimal points in the
display: the right decimal point flashes when the projector receives a command
and the left point flashes when the projector sends a command.
LCD STATUS DISPLAY WINDOW -
system status (such as an error). During normal operation, this display indicates
Power On and includes the frequencies of the vertical and horizontal syncs. The
display also shows if the On Screen Display (OSD, or menu system) is on or off.
The LCD displays the message Power Off when the breaker is on but the lamp is
off.
WIRED REMOTE KEYPAD CONNECTOR -
the projector.
Alternative location for working with the projector.
BUILT-IN KEYPAD -
INFRARED SENSORS -
projector receive infrared signals from the IR keypad for remote control of
projector functions. For proper operation, ensure these sensors are not blocked.
Laser radiation is emitted from the laser diode in the remote. Do not look
directly into the beam of the remote.
The projector is typically controlled using one of the following keypads:

Built-in Keypad at the rear of the projection head

Remote Keypad for tethered or tether-less control (includes cable for connecting
as a wired remote)
The breaker on the rear panel serves two purposes:
on the keypad.
Displays a text message describing the current
For optional tethered remote control of
The infrared (IR) sensors on the front and rear of the
This LED (light emitting diode)
Operation
3-3