Installing A Tape Drive - Gateway 995 User Manual

Chapter 4: Installing Components
7
Slide the cage out of the server toward the front.
8
Slide the new hard drive cage into the cage bay until it clicks into place.
9
Reconnect the three power cables and one SCSI ribbon cable to the back
of the cage.
10
Reinstall each hard drive into the slot it was removed from, then reinstall
each panel that was removed.

Installing a tape drive

Warning
To install a tape drive:
1
Follow the instructions in
page
cords and all other cables connected to the server.
2
Remove the front cover, if installed. For instructions, see
cover" on page
70
Although the tape drive bay is capable of holding a hard
drive, to maintain correct cooling you should not install a
hard drive in this bay.
36. Make sure that you turn off the server, then unplug the power
39.
www.gateway.com
"Preventing static electricity discharge" on
"Using the front