Installing A Cd Or Diskette Drive - Gateway 920 User Manual

Chapter 4: Installing Components
■ IDE hard drives can be configured as single, master, slave, or cable-select.
IDE CD drives can be configured as master, slave, or cable-select.
■
■
■
■ You may need to configure the drives you install using the BIOS Setup
utility. Press F2 at startup to open the BIOS Setup utility.

Installing a CD or diskette drive

Important
To install a CD or diskette drive:
1
Follow the instructions in
page
2
Open the server case by following the instructions in
case" on page
3
If you are replacing a drive, go to
- OR -
46
If cable-select is available (drive assignments will be marked on the
cable), the IDE cable assigns the master/slave positions to the drives
it connects. You can override these assignments using the jumpers on
the drives.
If you are connecting two IDE drives to the cable, connect the middle
cable connector to the slave drive and connect the end cable
connector to the master (boot) drive.
If cable-select is not available and only one drive is attached to an IDE
controller cable, configure the drive as master if it is a CD drive. If
two drives of any type are attached to the cable, configure one as
master and one as slave.
Drives connected to the primary and secondary IDE
connectors should be ATA100 drives, and drives
connected to the third IDE connector should be ATA66
drives.
41.
42.
www.gateway.com
"Preventing static electricity discharge" on
Step 6.
"Opening the server